The following couple of pics have been sneakily lifted from a fellow collaborators site and show part of the process in making a 'raised and fielded panel', which by a remarkable coincidence, is the next technical piece that I need to do for F&C.
The perpetrator in question is using a dedicated plane for the job...something that I won't have, but as you can see from the second pic...
...the edge of the panel is 'wedged' shaped. In other words, the bevel of the panel is flat, which I suppose is the traditional way that they've always been made.
However, this leaves me with somewhat of a dilemma.
When this wedged shaped panel is fitted into the corresponding square sectioned groove in the frame two things will happen.
First and foremost, if the panel expands (in the width) the wedge will tighten against the upper surface of the groove. Second and foremost, if it shrinks (in the width) a gap is going to develop 'twixt the upper surface and the frame groove and the result will be...
... a rattle! Eeeeeeeeeeeeeeeek!!
A little of delving around the Axminster site showed a panel raising cutter with a flat profile where the panel fits into the frame, so allowing it to expand and contract easily. From the perspective of making a better, rattle free panel this is clearly the best way of making the it.
My problem is, I've got to replicate this by hand...